Scratches Overlay

https://www.diynot.com › diy › threads
If he has calculated the beam based on 150 bearings then you need to get him to confirm the beam size again and the padstones But just use a 440x100x215 padstone and be done

https://www.diynot.com › diy › threads
Hello guys My surveyor says to get RC35 Padstones I asked Builders Merchants if they can supply RC35 Answer they gave Presumably they do Not helpful If they sell the stuff and

https://www.diynot.com › diy › threads
Hi guys just a little confused my drawing states that 215 width padstones are required but the two steels bolted together are 270 wide see attached so confusing Surely the padstone with

https://www.diynot.com › diy › threads
If there s a 400mm padstone estimate based on width of beam and the masonry is good a 150mm hole say 150mm 200mm below the padstone will have little effect on the bearing

https://www.diynot.com › diy › threads
Our builder is removing the external wall between our kitchen and garage Two bolted steels are going across the opening spanning around 2 2m This is the corner of the house so

https://www.diynot.com › diy › threads
Hi We are removing a load bearing wall supports first floor joists only and have had a SE come in a do the calc There is a door in the supporting wall and when we removed the load

https://www.diynot.com › diy › threads
Put in a proper sump pit Dig out a sufficiently sized hole place a 900x600 concrete paving slab at the bottom and build a pit on the slab out of 440x100x215 concrete blocks three

https://www.diynot.com › diy › threads
Hi all looking for some advice on what my builder has done here The project is a single story flat roof extension 6m x4m with 4m bi fold doors The builder has placed the steel beam across

https://www.diynot.com › diy › threads
Hello all D Can you use padstones on their side or must they be used a certain way up The ones I ve got are 102 high and 140 deep but my walls are 100mm so I want to use the 102