Pinthouse Pizza San Antonio Opening Date

https://www.eng-tips.com › threads
I want to use Inconel 718 for a valve stem and gate nut but need to know a few things first Is 718 susceptible to galling If it is will copper plating the nut threads help or will this cause

https://www.eng-tips.com › threads
I have not had any experience with Socrates but I have extensive experience with CES Edupack CES selector which was about all the information you would ever need and then some If

https://www.eng-tips.com › threads
The presentation by Socrates Ioannides is available here as E19 Rules of Thumb for Steel Design as a sound file with accompanying slides Well worth listening to for anyone interested

https://www.eng-tips.com › threads
I usually design steel columns for the connection eccentricity but Socrates Ioannides has published a couple papers that say a typical sheartab connection provides rotational restraint to

https://www.eng-tips.com › threads
Is there a best practices approach to designing columns using Risa Floor and 3 D I work on relatively straightforward low rise buildings for the most part but the axial loads can get up

https://www.eng-tips.com › threads
Those Socrates rules of thumb are intended for building design It looks like a fair amount of your steel is unbraced so those rules of thumb would likely underestimate what you actually need

https://www.eng-tips.com › threads
Has anybody encountered the little conical fillers that can be used in repair work to fill the countersink when one applies a doubler over top I ve been shown these before by a repair shop

https://www.eng-tips.com › threads
What I don t know is how to write a ISO macro with variables for use with mazatrol AND call it from a mazatrol program I m not sure how the camware dialog works to call the macro and I m

https://www.eng-tips.com › threads
Need a calculation for sizing nitrogen piping with these parameters 250 psig working pressure 11 cfm volume 65 F temperature 418 ft of run also need info on pressure relief valves